英语
中文简体
西班牙语
德语
Zinc Plated half thread Mushroom Head Square Neck Carriage Bolt DIN603,M 6 /8
Diameter range (mm)：M5-M24，3/16-1'Length range (mm)：16-600，1''-2'
Due to the practical characteristics of the hexagonal bolt itself and other problems, the outer diameter of the threaded teeth is small. With ordinary bolts, the outer diameter of the teeth will slide when the outer diameter is small. At present, the hex bolt manufacturer has improved the thread sliding solution, standardized the use of the thread, selected the appropriate thread, customized or purchased the appropriate thread, and used high-quality bolt materials to make the thread more rigid. The hex bolt manufacturer The high-strength bolt connection has been assembled, and the high-strength bolt connection is assembled at both ends.
Regarding the products of the hexagonal bolt manufacturer, whether the processing temperature of the product is too low or the heating temperature is too low, the springback after bending cannot be reduced well. The heating temperature is too high, and the surface of the workpiece is excessively oxided, which will affect the surface quality of the workpiece. . After quenching, the workpiece may be deformed. In order to reduce deformation, use oil as cooling water during quenching, and choose a slower cooling rate to reduce the internal stress of the workpiece, which can reduce the deformation of the workpiece after quenching. The effect of the above processing technology production practice is completely feasible. With the advancement of science and technology, the requirements for materials are getting higher and higher.
At present, standard parts have their own requirements for the production of raw materials, most of which are steel wires or steel wires. Hex Bolts Manufacturers can use them to produce hexagonal bolts and other fasteners, especially according to the strength requirements under working conditions and the corrosion resistance requirements of the material. Select applicable materials according to relevant national standards. The length of the screw is insufficient and the hardness is not enough to withstand the corresponding torque. The combination is insufficient due to the inability to withstand the torque of the screw strength and the appropriate torque.
